If lit steadily, paper feed
|
Код ошибки |
Описание |
|
CH |
If lit steadily, paper feed section cover is open or manual feed unit not installed properly. If flashing, developer seal still installed, or toner density sensor/main board problem. |
|
EE |
Sub code EU: undertoned. May be toner density sensor problem or developer unit problem. Sub code EL: Over toned. May be toner density sensor problem or developer unit problem. |
|
H2 |
Sub code 0: Fuser thermistor. |
|
H3 |
Sub code 0: Fuser temperature too high. |
|
H4 |
Sub code 0: Fuser temperature too low. |
|
L1 |
Scan problem. Sub code is 0, but there is no more detail. Could be no scan drive; scan did not leave home; scan did not return home; scan overloaded; mirror motor problem; scan cable came off. |
|
L3 |
Scan return problem. Sub code 0. Approximately same causes as L1 |
|
L4 |
Sub code 1: Main drive problem. Sensor, gear, motor. |
|
L5 |
Sub code 2: Lens drive, motor, sensor. |
|
L8 |
Sub code 1: Power frequency varies by more than 5 % or for more than 5 sec. Sub code 3: AE sensor problem. |
|
PC |
Key counter not installed. |
|
SPFJAM |
Document feeder problem. |
|
U2 |
Sub code 1: Main board EEPROM problem. Sub code 4: Memory problem. |
|
U5 |
Sub code 5: high temperature at exposure glass when using document feeder. |
