F.A.Q. по ремонту и обслуживанию копиров

       

Door open or developer unit




Код ошибки

Описание

C2

Transfer corona problem or HVT

CC

Original detection problem.

CH

Door open or developer unit not installed, not connected properly, or not latched in place properly.

F1

Sub code 00: Communication error between main board and sorter. 01: Jogger error. 02: Sorter transport motor drive. 04: Sorter bin sensor problem. Lower limit sensed wrong.

F2

Sub code 02: Toner motor problem. 31: Image density sensor problem. Could be a problem with the light level. 32: Drum mark sensor problem. Does not see mark on drum or sensor does not work properly. 35: Grid voltage correction will not work during simulation.

F3

Sub code 12: Copier upper cassette lift motor problem. Copier bottom cassette lift motor problem.

H2

Fuser thermistor open.

H3

Fuser temperature too high.

H4

Fuser temperature too low. Lamp, thermal switch, connections.

L4

Sub code 01: Drive problem, main motor, sensor, bind.

L5

Sub code 03: Drive problem with 4th/5th mirror assembly, motor, sensor, board.

L8

Sub code 01: Power frequency problem.

PC

Card counter or key counter not installed.

PF

There is an inhibit command from the PC modem. This is reset with simulation 17.

U2

Sub code 00 or 01: Memory error.

U3

Sub code 20: Mirror motor locked. 21: Mirror motor home sensor.

U4

Sub code 02: Duplex alignment plate out of position motor, cable, sensor.

U5

Sub code 00: Communication problem between main board and RADF. 01: RADF motor drive problem. 02: RADF motor drive problem. 03: RADF resist sensor. 04: RADF exit sensor.

U6

Sub code 00: Communication error between copier and desk. 01, 02, 03: Desk lift motor drive problem. 08: Desk 24v problem. 09: LCT motor overload. 10: Desk transport motor drive problem.

U7

Sub code 00: Communication problem between copier and PC modem.


Содержание раздела