Memory problem. Main board or
|
Код ошибки |
Описание |
|
AP |
CC50. Toner being mixed |
|
C01 |
Memory problem. Main board or simulation 70 required |
|
C02 |
EEPROM or main board |
|
C21 |
Drive problem (CC50/1256) |
|
C30 |
Scan |
|
C40 |
Lens drive |
|
C61 |
Fuser problem. No heat or open circuit |
|
C63 |
Fuser thermistor open |
|
C64 |
Fuser thermistor. Short or high fuser temperature |
|
C72 |
1256 drum thermistor open |
|
C73 |
1256 drum thermistor shorted |
|
C74 |
CC50/1256 Developer unit fuse. May have to replace developer unit. Problem at setup |
|
C74 |
1257 Developer thermistor |
|
C75 |
CC50/1256 Drum unit switch problem or drum setup problem |
|
C75 |
1257 developer thermistor |
|
C76 |
May not apply to CC50 or 1256, except if metric. Waste toner full. Reset with simulation 78 |
|
J01 |
Feed jam |
|
J02 |
Drum or fuser area jam |
|
J03 |
Jam |
|
OF |
1256 drum & developer units must be replaced |
|
OP |
Front door open |
|
PE/PF |
No paper, no paper feed problem |
|
U1 |
Total counter |
|
Ub |
CC50. Old developer unit and new drum. Can be reset by replacing the fuse, or by turning the drum one full revolution |
|
Uc |
CC50. New developer unit and old drum. On rear of drum is drum lock. Inside the opening is a white plastic that snaps down after the unit is installed. Remove this rear cover and snap the white plastic blocker back up |
|
UF |
Toner or developer not installed properly |
