Zero cross of DC power
|
Код ошибки |
Описание |
|
F18 |
Paper feed lift problem |
|
F18-3 |
LCT problem |
|
F18-4 |
LCT problem |
|
F28-1 |
Charge corona |
|
F28-2 |
Transfer or separator corona |
|
F34-1 |
High fuser temperature |
|
F34-2 |
High fuser temperature |
|
F35-1 |
Low fuser temperature |
|
F35-2 |
Low fuser temperature |
|
F36-1 |
Low fuser temperature |
|
F36-2 |
Low fuser temperature |
|
F41 |
Scan return problem |
|
F42 |
Scan forward problem |
|
F43 |
Exposure lamp board problem |
|
F45 |
Lens home problem |
|
F52 |
Main motor drive problem |
|
F55 |
Zero cross of DC power supply |
|
F60 |
Communication interruption between the machine and RADF |
|
F67 |
RDH or RADF drive problem |
|
F70 |
Communication problem between machine and sorter |
|
F77 |
Sorter bin problem |
|
F78 |
No memory card installed |
|
F86 |
Too many copies were made after toner waste was full. Reset with 47 mode, Код ошибки 94. |
|
F98 |
Duplex guide plate does not return home quickly enough |
|
J10 |
Feed jam |
|
J11 |
Upper feed jam |
|
J12 |
Lower feed jam |
|
J13 |
Upper paper feed unit jam |
|
J14, J15 |
Lower paper feed unit jam |
|
J16, J17 |
Jam in machine |
|
J19 |
Paper feed unit jam |
|
J21 |
Jam around drum |
|
J31 |
Exit jam |
|
J32 |
Exit jam |
|
J61, J62 |
RDH/RADF jam or open |
|
J63 |
RADF exit jam |
|
J72 |
Sorter jam or open interlock |
|
J74 |
Finisher problem |
|
J75 |
Stapler problem |
|
J92-J95 |
Duplex jam |
|
P17 |
Right side door open |
|
P19 |
Paper feed unit door open |
|
P33 |
Exit door open |
|
P51 |
Front door open |
|
P61 |
RADF cover open |
|
P64 |
RADF not opened to remove originals |
|
P68 |
Original removed during operation of RADF |
|
P69 |
Original didn't feed during RADF/RDH operation |
|
P71 |
Sorter interlock |
|
P74 |
51 copies or more went into the stapler or paper was in the sorter/stapler, or different size originals were used in the staple mode, or more than 25 copies per bin were attempted by the stapler. |
|
P76 |
Out of staples |
|
P78 |
Stapler not installed |
|
P81 |
Key counter not plugged in |
|
P82 |
Memory card not installed, not formatted to Konica specs, or no machine serial number registered on memory card |
|
P86 |
No toner waste box |
|
P91 |
Duplex unit pulled out |
|
P96 |
Paper in duplex tray |
|
P97 |
Bypass was used or attempted during duplex. |
|
P99 |
Too many reverse side copies during duplex |
