Код ошибки
|
Описание
|
04
|
PTC heater. Don' t know what this is, but "0" means it is not installed. 1 means it is.
|
F09
|
Power leakage of some kind. Heat, exposure, AC or power supply or main relay. Go to "25 mode" and select "P49" and reset to "0"
|
F23
|
Toner motor
|
F26
|
Toner density adjustment problem. This means the machine is undertoned. To repair, replace developer and enter "47" mode. Press 51. Press print. Allow the machine to cycle until it stops. Some feel you should disconnect the toner motor first. This Код ошибки happens probably because either the machine wasn't set up properly, or because the customer kept using the machine with the light on.
|
F28
|
Corona problem. Could be any corona.
|
F34
|
High fuser temperature.
|
F35
|
Low fuser temperature.
|
F36
|
Low fuser temperature.
|
F41
|
Scan home
|
F43
|
Exposure lamp or exp. Lamp board.
|
F44
|
Lens drive problem.
|
F45
|
Lens problem.
|
F54
|
Fan motor.
|
F60
|
ADF to main board communication problem.
|
F67
|
ADF enКод ошибкиr (pulse sensor, drive problem)
|
F70
|
Sorter to machine communication problem.
|
F77
|
Sorter gate.
|
F88
|
AE adjustment problem.
|
J11-J13
|
Feed jam
|
J14-J16
|
Jam inside
|
J31, J32
|
Exit jam
|
J61, J62
|
ADF jam
|
J63
|
ADF exit jam
|
J72
|
Sorter jam
|
P11
|
Count. For total count, select "0". For developer count, select "5".
|
P12
|
Preheat mode fuser temperature. 0 for 365 degrees. 1 for 374 degrees. 2 for 383 degrees.
|
P15
|
Size priority. 0 is standard. 1 is a size priority.
|
P16
|
Paper size priority.
|
P19
|
Preheat shut off timing. 0 for 1 hour. 1 for 2 hours. 2 for 3 hours.
|
P20
|
Drum unit or toner level connection problem. Most likely, a loose connection.
|
P22-P24
|
Kind of obscure. This sets the wait time for tuning intermittent test copies in a 36 mode test.
|
P25
|
300 copies have been run since toner light came on, depending on how 25 mode, Код ошибки 92 is set, machine may not work at all.
|
P26
|
ADF border erase. 0 for none. 5 for 5mm.
|
P26
|
Must replace and calibrate developer.
|
P27
|
PM cycle. 27 is for the 5th digit. 28 is for the fourth digit.
|
P27
|
Toner density sensor unplugged or toner density sensor problem.
|
P28
|
PM cycle. 27 is for the 5th digit. 28 is for the fourth digit.
|
P64
|
ADF & operator are confused. Remove original.
|
P68, P69
|
ADF feed problem.
|
P71
|
Sorter interlock.
|
